Product Data Sheet Show all documents
Ronabond® EFC

Ronabond® EFC

Polymer Modified Pre-bagged External Fairing Coat

Ronabond® EFC is a prepacked fairing coat which is applied as a skim coat in thicknesses up to 3 mm to provide a smooth, hard finish to damaged, blemished and repaired external concrete surfaces. Ronabond® EFC is also used as a smoothing mortar prior to the application of protective coatings and paints. The material is supplied in preblended form which can be mixed by hand or machine.

  • Excellent water resistant
  • Can be applied by trowel or spray
  • Prepacked for site control and efficiency
  • Harder than plaster finish in secure areas
  • Improved carbonation protection
  • Can be applied as a thin 1 mm skim coat
  • Low VOC
  • Can contribute to LEED certification
Product Data Sheet Show all documents

Usage

  • Prepacked EFC for levelling new and old external surfaces prior to coating
  • Smoothing concrete surfaces following concrete repair
  • Filling blowholes and surface blemishes
  • Protection of external facades
 

Advantages

  • Excellent water resistant
  • Can be applied by trowel or spray
  • Prepacked for site control and efficiency
  • Harder than plaster finish in secure areas
  • Improved carbonation protection
  • Can be applied as a thin 1 mm skim coat
  • Low VOC
  • Can contribute to LEED certification

Packaging

25 kg bag

Colour

Concrete grey

Product Details

Product Information

Shelf life

9 months from the date of production

Storage conditions

Stored properly in undamaged and unopened original sealed packaging in the dry conditions. Protect from direct sunlight and frost.
Technical Information

Tensile Adhesion Strength

> 1.0 MPa

Water Absorption

Ronabond® EFC

Typical Performance

Test Method
0.0278 ml/m2/sec @ 10 min

Initial Surface Absorption Test

0.0117 ml/m2/sec @ 30 minInitial Surface Absorption Test
0.0095 ml/m2/sec @ 60 minInitial Surface Absorption Test

Application

Application Information

Pot Life

Approx. 30 minutes @ 25 oC

Setting Time

2–4 hours (Final)
Consumption

Yield

1.7–2 kg/m2/mm
Application steps

MIXING

Add approximately 5.5 litre of clean water per 25 kg bag of powder. Mix with a mechanical forced action mixer for a minimum of 2 minutes until the powder has fully dispersed. Leave to normalise for 5 minutes and briefly remix before use, do not add additional water.

APPLICATION

Apply EFC on to dampened surface by trowel or spray. The surface should be sponge or tight trowelled for a smooth finish before dry. It is recommended that for aesthetics reasons only, Ronabond® EFC is covered with a protective and/or decorative coating.

CLEANING OF EQUIPMENT

Clean all tools and application equipment with clean water immediately after use.

Documents