Product Data Sheet Show all documents
Ronabond® 2 in 1 Tile Adhesive and Grout

Ronabond® 2 in 1 Tile Adhesive and Grout

Prebagged single part 2 in 1 tile adhesive and grout

Ronabond® 2 in 1 Tile Adhesive and Grout is a single part polymer modified cement-based tile adhesive and grout. It is specially formulated for fixing mosaic tiles and other tiles where bonding and grouting will be completed in single process and one product only. Ronabond® 2 in 1 Tile Adhesive and Grout is compatible with most cementitious substrates, glass mosaic tiles and ceramic tiles. Ronabond® 2 in 1 Tile Adhesive and Grout is a pre-bagged single part product requiring only addition of water to produce tile adhesive and tile grouting materials.

  • Prepacked for control and convenience
  • Simple to mix and easy to apply
  • Single product for both tile bonding and joint grouting
  • High bond strength
Product Data Sheet Show all documents

Usage

  • Bonding for mosaic and ceramic tiles
  • Internal and external application
  • Swimming pools
  • Kitchens, bathrooms, showers, lobbies
 

Advantages

  • Prepacked for control and convenience
  • Simple to mix and easy to apply
  • Single product for both tile bonding and joint grouting
  • High bond strength

Packaging

25 kg bag

Colour

Brown and White

Product Details

Product Information

Shelf Life

9 months from the date of production

Storage Conditions

Stored properly in undamaged and unopened original sealed packaging in the dry conditions. Protect from direct sunlight, moisture and frost.
Technical Information

Tensile Adhesion Strength

> 0.5 MPa at 28 days

Application

Consumption

Yield

4–7m2 per bag depending on bedding thickness, joint and tile size
Application steps

MIXING

Mix Ronabond® 2 in 1 Tile Adhesive and Grout with the correct amount of clean fresh water using a mechanical mixer until an even consistency has been achieved. Approximately 6.0–6.5 litres of clean water should be added to each 25 kg bag of Ronabond® 2 in 1 Tile Adhesive and Grout. Allow the mixed adhesive to stand for 5 minutes, then remix immediately before applying. Do not add further water.

APPLICATION

Ensure the substrate is saturated and free of running or ponding water. Use a straight edged plastering trowel; spread the mixed materials onto the surface for tiling. Limit the area that will have tiles set to the surface whilst the applied materials are still tacky. Use a notched trowel to form ribs into the surface of the applied materials. Spread a thin coat of materials onto the back of tile ensuring all tile joints are fully grouted with the materials. Check the materials surface for tackiness using a finger, prior to placing tiles. Non-tacky materials must be removed. Set and tap the tiles well into place, ensuring void-free contact into the tacky materials. Check for complete adhesive contact by prizing off a tile. Allow the materials sufficient time to achieve initial set and hardness; when tiles can no longer be adjusted. Remove the paper mounted on the tiles and clean the tile surface using a damp sponge to remove surplus materials.

 

  

Movement Joints

Form movement joints in accordance with BS5385. For maximum effect and compatibility, fill joints using Sikaflex® sealant.

CLEANING OF TOOLS

Clean all tools and application equipment with clean water immediately after use.

Documents