Product Data Sheet Show all documents
Monotect

Monotect

Surface Dustproofer and Hardener

Monotect is a liquid surface hardener and dustproofer for new and old concrete. It is supplied ready for use and is quick and easy to apply. Within 48 hours the surface treated is ready to use. Note that Monotect is designed for application on to porous and dusting concrete and not those which have a dense surface finish or are waterproof (e.g. contain Ronafix® or are based on a similar product). The chemicals in Monotect react with the free lime in the concrete and convert the particles to hard, stable crystals. These crystals are bonded to the concrete and become an integral part of it.

  • Simple to use
  • Cost effective
  • Excellent durability
  • Reduces ingress of chemicals
  • Low VOC
Product Data Sheet Show all documents

Usage

  • Hardening new and old concrete floors
  • Dust-proofing new and old concrete floors

Advantages

  • Simple to use
  • Cost effective
  • Excellent durability
  • Reduces ingress of chemicals
  • Low VOC

Packaging

5 litres drum

30 litres drum

Product Details

Product Information

Shelf life

9 months from the date of production

Storage conditions

Stored properly in undamaged and unopened original sealed packaging in the temperature range +5 oC to +25 oC. Protect from direct sunlight and frost.

 

Application

Consumption

Yield

Coverage is determined by the porosity of the concrete. For estimating purposes a figure of 6–8m2 per litre of Monotect per coat can be used.
Application steps

SUBSTRATE PREPARATION

The floor should be clean, free of oil and grease and dry (slight dampness is acceptable). New concrete should be left for seven to fourteen days before applying Monotect. Remove contamination and lightly abrade the concrete floor by wire brushing or similar to open up the matrix of the concrete so that the Monotect can soak into the composite and react.

APPLICATION

First Coat

Pour or spray the material over the concrete surface and sweep in all directions (with a brush, broom or squeegee) until no more is absorbed. Any dry spots should be re-treated. Remove excess Monotect with a soft broom or squeegee. Allow the Monotect to be absorbed into the concrete leaving a dry surface. A drying period of 12–24 hours is normally sufficient. Avoid ponding, as this will prevent the material correctly functioning.

 

Second Coat

After 12–24 hours apply the second coat. Avoid ponding as this will prevent the material correctly functioning. Make certain that excess Monotect is removed. After 12–24 hours sweep the concrete surface to remove surface crystal growth. Sweeping may need to be repeated for some time whilst the reaction continues.

CLEANING OF EQUIPMENT

Clean all tools and application equipment with clean water immediately after use.

Documents