Product Data Sheet Show all documents
Ronabond® MAQ

Ronabond® MAQ

Dry Shake Non Metallic Floor Hardener

Ronabond® MAQ is a specialist dry shake floor hardener based on special blend of graded mineral aggregates, 525 grade Ordinary Portland Cement, dry pigment and additives. It is graded for optimum density to achieve maximum hardness when correctly applied over freshly placed concrete floors or cement sand screeds.

  • Non dusting and ease of maintenance
  • Hard wearing, which resist oil and water attack if properly treated
  • Non skid and can withstand forklift traffic
Product Data Sheet Show all documents

Usage

  • Car park
  • Warehouse
  • Hangers
  • Industrial floors

Advantages

  • Non dusting and ease of maintenance
  • Hard wearing, which resist oil and water attack if properly treated
  • Non skid and can withstand forklift traffic

Packaging

25 kg bag

Colour

Cement grey

Other colours on request

Product Details

Product Information

Shelf life

9 months from the date of production

Storage conditions

Stored properly in undamaged and unopened original sealed packaging in the dry conditions.

Protect from direct sunlight and frost.

Application

Consumption

Consumption

5 kg to 7 kg per m2 (Heavy duty)

3 kg to 4 kg per m2 (Moderate duty)
Application steps

SUBSTRATE PREPARATION

The concrete shall be placed and screened using proper tools and equipment to prevent segregation. Consolidate and level the slab further with a power float before any bleed water appears. 

The slab shall be floated before the application of the first shake (aggregate mixture). All floating operations shall be done in two directions perpendicular to each other. 

APPLICATION

The first shake which consists about 2/3 of total shall be broadcasted evenly across the surface after the bleed water has disappeared. The first shake is then floated into the surface, starting on the floor adjacent to walls, columns etc. Continue floating to bring moisture up through the Ronabond® hardener and embed the hardener into the surface of the slab. 

The second shake is then broadcasted at right angle to the first shake. The first trowelling starts when the concrete is able to sustain a foot pressure of not greater than 6 mm indentation. Additional trowelling continued until desired finish is obtained.

CURING TREATMENT

If required, Monocure 50 curing compound should be used for sealing purpose.

CLEANING OF EQUIPMENT

Clean all tools and application equipment with clean water immediately after use.

Documents