Product Data Sheet Show all documents

Ronadeck® Resin Bound Surfacing

Permeable Resin Bound Paving System

Ronadeck® Resin Bound Surfacing (RBS) is a resin bound aggregate system suitable for pedestrian traffic. Designed to be trafficable, durable and highly decorative the system can also promote the good health of the subsoil by allowing rainwater to drain directly to ground rather than to the sewage system. The system is based around specially graded natural aggregate blends and a high performance resin manufactured specially for Hong Kong conditions. RBS is intended for refurbishments, new construction and general landscaping applications both indoor and outdoor.  With appropriate attention to design RBS can be laid onto most sound substrates such as concrete, asphalt, compacted sub-base, no fines concrete and in some circumstances tiles and block-work.

  • Decorative
  • Trafficable
  • Permeable
  • Potentially seamless
  • UV Stable / Non Yellowing
  • Non toxic
  • Fast curing
  • Can achieve high slip resistance
  • Easy to Install
Product Data Sheet Show all documents

Usage

  • Paths, pavements, cycle tracks and steps
  • Patio’s and swimming pool surrounds
  • Shop floors / water features etc
 

Advantages

  • Decorative
  • Trafficable
  • Permeable
  • Potentially seamless
  • UV Stable / Non Yellowing
  • Non toxic
  • Fast curing
  • Can achieve high slip resistance
  • Easy to Install

Packaging

114.5 kg pack

Product Details

Product Information

Shelf life

6 months from the date of production

Storage conditions

Stored properly in undamaged and unopened original sealed packaging in the temperature range +5 oC to +30 oC. Protect from direct sunlight and frost.

Product Declaration

Permeability

Approx. 5–100 litre/m2/min

Compressive Strength

Approx. 5–15 MPa

(CS1 : 2010 : Section 12)

Transverse Breaking Load

Approx. 50–200 N/mm

(BSEN 1344 : 2002)

Tensile Strength

Approx. 5–12 N/mm2

(BSEN 1344 : 2002)

Slip Resistance

> 45 USRV

(BS EN 1341 : 2001)

Remark : The above data could be varied depend on the aggregate mix.

Application

Application Information

Ambient Air Temperature

> 5 oC
Application steps

MIXING

Pre-mix the coarse aggregate in a suitable forced action pan mixer. Pre mix all of the Part A and Part B resin pack using a drill and paddle. Use a medium speed and try to avoid introducing too much air into the mix. This is especially important when there is high humidity. Mixing should take between 30 second to 1 minute. Pour the pre-mixed resin into the forced action mixer and blend for 2 to 3 minutes until all of the aggregate is evenly coated with resin. If fine aggregate is included in the mix add this after the resin has completely coated the coarse aggregate and mix for an additional 1 minute.

APPLICATION

Spread the aggregate at the desired location using a rake or other leveler to achieve an un-compacted level of between 25 % and 50 % greater than the desired thickness of the system. Use a screed trowel with a compacting force to achieve the desired level and a smooth finish. The minimum application thickness after finishing should be 15 mm. Protect the system from trafficking, rain, dirt and contaminants for at least 4 hours.

CLEANING OF EQUIPMENT

Clean all tools and application equipment with thinner immediately after use. Hardener and/or cured material can only be removed mechanically.

Documents